How to auto fill reassessment inherent and residual answers from previous risk assessments to a new
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-17-2022 08:07 AM
I have request where the risk user would like to see what they have selected for a previous risk assessment.
Is it possible to copy the inherent and residual answers from a previous risk assessment to the new risk assessment which has been generated or at least show it somewhere on the new risk assessment generated.
Thanks
H
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-17-2022 09:14 AM
Hello, are you using Advanced Risk? If so there is Risk Assessment Methodology, where you can configure to copt previous assessments to the new assessment
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-17-2022 10:45 AM
Hi @rajeeshraj
Thank you for this, yes I am using advanced risk. I have selected this option but I cannot see where it has copied the previous assessment when a new assessment was generated as initiated. Am i missing something here?
I also noticed I dont have a scheduled tab on the risk assessment methodology aswell which shows the frequency.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-17-2022 11:58 AM
Can you verify if the Show previous assessment checkbox is checked?
These settings will not automatically copy a previous assessment, rather it gives an option on the current assessment to copy a previous assessment
image attached
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-17-2022 12:38 PM
Hi @rajeeshraj
Please see the box which is ticked, if the user has the option then no UI action is available. Have you got a screen shot of what it should look like please?
Thanks again
H