---
sourceDocument: Brazil Governance, Risk, and Compliance
sourceDocumentLink: https://www.servicenow.com/docs/r/governance-risk-compliance

 Release :

    - brazil

ft:locale :

    - en-US

ft:publication_title :

    - Brazil Governance, Risk, and Compliance

ft:clusterId :

    - grc

bundleId :

    - grc

workflow :

    - Technology


---

# Configure the Connector configurations

# Configure the Connector configurations {#ariaid-title1}

Release version: Brazil  
Updated September 10, 2026  
![](https://www.servicenow.com/docs/portal-asset/ico-clock) 1 minute to read  
Review and update the Connector configurations for the selected Nexus map configuration. You can configure the label, tooltip, and default Connector type for each connector between
nodes.

## Before you begin

Role required: sn_oper_res.admin

## About this task

The system automatically creates a Connector configuration for each Node relationship configuration in the Main node configuration when you create the Nexus map configuration. To pick up later changes to the Main node
configuration, use the Sync from main node configuration UI action on the Nexus map configuration.

## Procedure

1. Navigate to AllData Relationships FrameworkMain node configuration and open the desired Main node configuration from the list view.
2. Open the Nexus map configuration record from the Nexus map configurations related list.
3. In the Connector configurations related list, open the Connector configuration record that you want to configure.  
   For more information on the fields, see [Connector configuration form](https://www.servicenow.com/docs/9HjtBzAkjg7UM8xiphgHpQ "Use the Connector configuration form to view and configure the label, tooltip, and default Connector type for the connector between the selected nodes.").  
   The Nexus map configuration, Node relationship configuration, Source table, Target table, and Relationship table fields are read-only in the Connector configuration record.
4. To mark the Connector configuration as active, select the Active option field.
5. Select the label for the connector in the Label field.
6. Select the tooltip for the connector in the Tooltip field.
7. Select the default connector type in the Default Connector type field.
8. To clear the selections for the label and tooltip, select Clear selections.
9. To save your changes to the Connector configuration, select Save.
{#configure-edge-configurations__steps_frz_lws_fhc}

*[\>]: and then