Flow designer

[LI QD]

I have a flow designer. When I created the record, the flow is start.
There is a [ Wait for condition ], it is wait the Field A changed.

when Field A change, through  [Update Record] to change Field B.
But [Wait for condition]  took long time to be executed.

There are some warning messages in Flow engine log entries.

I would like to ask why these warning messages were reported?

Please!!!

Aborting engine execution because a cursor was not found for context: sys_id waiting on message: {"cursorLabel":"DEFAULT","waitToken":"hLNspQo5z18hTyf6XtMyUr2PvZaoAmy6","message":"RW"}

Wait for condition monitor found satisfied condition: op(Flow Name Flow.sys_id-WFCResume) plan(sys_id)

[Ankur Bawiskar]

@LI QD 

please share some screenshots.

Is everything working as expected even after warnings?

If yes then it should be fine, you need not worry on the warning messages.

That message might be coming due to the wait condition as Flow waits for some condition to get true

If my response helped please mark it correct and close the thread so that it benefits future readers.

[LI QD]

Hi

Thank you for your answer!

Although it was finally successfully updated, it was a long wait (15s~30s).

So I want to know why the messages are reported and how to avoid this.

[Ankur Bawiskar]

@LI QD 

Hope you are doing good.

Did my reply answer your question?

If my response helped please mark it correct and close the thread so that it benefits future readers.