How to activate a read-only flow

Go to solution
MongGu
Tera Guru

‎01-10-2024 08:32 AM

If I mistakenly deactivate the read-only flow, how can I activate it? 

 

The buttons for activate are disabled and I cannot change the property of the flow from read-only to none (disabled also). 

 

For example, from the PDI -> Flow Designer, if I deactivate the flow "Change - Emergency - Authorize," I cannot activate it again since the flow is the read-only. 

0 Helpfuls
  • 2,957 Views
1 ACCEPTED SOLUTION

Go to solution
MongGu
Tera Guru
In response to Dr Atul G- LNG

‎01-10-2024 08:43 AM

Thanks for the information. I already tried those two links before but still were not working and not behaving the same. 

 

Maybe it is impossible for me to activate it again looking at this article: https://www.servicenow.com/community/developer-forum/protection-policy-is-set-to-read-only/m-p/19156...

View solution in original post

0 Helpfuls
5 REPLIES 5

Go to solution
Dan Covic2
Tera Contributor
In response to Alec_Schechter1

‎04-14-2025 01:42 PM

Yes, this technique worked for me on Yokohama Patch 2 release. Thanks!

0 Helpfuls