We're bringing in our network gear info primarily using Cisco Catalyst Connector, however it's creating switch stacks as one CI instead of multiple (it also misses the relationships, so we will be using Discovery) and is just concatenating Serial numbers and models. I believe the data is stored this way in CC as well, but I'm not familiar with the tool and if it's typical for it to look that way. Discovery is scanning the switches properly and creating multiple CIs for a stack, and relating them to each other, but then CC isn't detecting those CIs for itself and updating them. Is there anyway to get CC and Discovery to play nice with the CIs? Ideally we'd have Discovery scan and create them, and Catalyst would update the other non-discoverable information, but if it's not looking at switch stacks properly, we have problems.
