IP Switch discovery ?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-26-2020 11:18 PM
IP switch discovery keep changing the ip address while discoverer
i could see in network adapters field ( 3 vlan ip address) and updating those ip address in the cmdb
so those all are switch ip ? or what is primary ip for this device
- Labels:
-
Discovery
-
Event Management
-
Service Mapping

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-27-2020 02:29 AM
Hi,
Yes the network adaptors can be used to discover the switch. So if discovery schedule see this IPs in one schedule and if you are using probe bases discovery then you will see that it will discover the CI with one IP and other IPs will be marked as Identified, ignored extra IP.
But in pattern based discovery it keeps flipping between those IPs.
Thanks,
Ashutosh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-27-2020 05:58 AM
If you are using the Network Switch pattern to discover the switch, the IP address may be changing because of duplicate switch discoveries in the same discovery schedule. The issue is documented in this community article: