Reapply All Remediation Target Rules
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎06-17-2025 12:23 PM - edited ‎06-17-2025 12:55 PM
We recently recreated our remediation target rules and have been rolling them out in phases to UAT. There are some VIT's that are not being assigned a remediation target rule, despite there being a VIT that meets the conditions of the remediation target rule. As a troubleshooting effort, we disabled all remediation target rules and enabled them again in order to set "Reapply = true." Unfortunately, the same VIT's in question did not get a remediation target rule assigned. Yet, when we use the VR Workspace UI and Re-evaluate remediation target properties, the VIT's in question will have a remediation target assigned. The exact one that we thought it should have been applied previously.
Is there a more viable work around to reapply remediation target rules so that all rules are applied instead of the ones that are set to Reapply = true or by using the VR Workspace UI?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎06-19-2025 07:34 AM
Hi @14Hernan
Open the rules, make the first record to inactive, then again make it to active, now Reapply field will changes to "Yes". Click on Apply Changes Button to apply the rules.
go through below link to know more about remediation target rules
https://www.servicenow.com/docs/bundle/xanadu-security-management/page/product/vulnerability-respons...
https://www.servicenow.com/community/secops-vr-forum-read-only/target-remediation-rules/m-p/2369280
Thanks
Yamsani Bhavani