why doens't manufacturer contact autopopulate in section 7 of lab 7.1.1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-23-2025 02:21 PM
I think I messed up the configuratiohn somewhere?
screenshot below (circled in black):
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-24-2025 01:22 AM
Hi @hikerclimber,
for the labs, it will be difficult to give you any advice as you have to enrol for a particular course, from your description it is not even clear what module it is...
Try to repeat the steps from previous lab again, it might be due to some mistake from the previous lab or it can be a bug. Hard to say.
However, if it is not blocking you, the whole class can be completed with 80 % of the labs, so you can try to debug and investigate but if not working, you can skip it.
/* If my response wasn’t a total disaster ↙️ ⭐ drop a Kudos or Accept as Solution ✅ ↘️ Cheers! */
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-24-2025 01:26 AM
Hi @hikerclimber,
You need to check your Lab steps and see if any missed something. If the autopopulate is part of task and you had to configure it, check the configuration, otherwise you may ignore it.
Labs can be completed at 80% progress.
Regards,
Ehab Pilloor