Focus Group for ATF?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎07-02-2024 03:05 PM
Can anyone point me to which community board is focused on ATF development and testing questions?

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎07-02-2024 08:57 PM
Hi there,
There's no dedicated ATF / testing board.
Kind regards,
Mark Roethof
Independent ServiceNow Consultant
10x ServiceNow MVP
---
~444 Articles, Blogs, Videos, Podcasts, Share projects - Experiences from the field

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎07-02-2024 09:48 PM
Hi @TStimple - further to @Mark Roethof's answer: don't let that stop you if you have an ATF question you want answered. Posting it here in the Upgrades and Patching forum is probably as good a place as any.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎07-03-2024 08:15 AM
Hey Simon Thinks. I will Post here.
I am trying to create a simple ATF test that adds an item to the Affected CI tab in an Incident record.
I run a step to confirm the related list is visible on the Incident record (successful) but in the next step to 'Click a UI action on a related list' I get a failure that says the Related list is not found on the open form. Am I missing something? I have attached screen shots.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎07-03-2024 08:09 AM
Hello, Thanks Simon. I will post here.
I am a newbie to ATF development and testing. I am not a SN Admin.
I am trying to create a simple ATF test that will add an item to a Related List (Affected Cis) on an Incident form.
I run a step to verify that the Related list is visible (successful), but on the next step I try to "Click a UI action on a related list" I get a failure error that the 'List is not found on the open form'. I have included a screen shot of these three steps. Am I missing some obvious step?