Dynamic IRE
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
yesterday
Hello,
I have implemented Dynamic IRE in simulation mode. In simulation mode, I am not able to see any comparison.
Can anyone please guide on this?
Thanks.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
yesterday
Hey @sntech
In Dynamic IRE Simulation Mode, both Dynamic IRE and Static IRE process the same incoming CI payload in parallel. The comparison results are stored in the cmdb_ire_output_comparison_item table.
I would suggest checking the following:
- Trigger CI ingestion: Run a Discovery cycle or send CI payloads through the IRE API. Simply enabling Simulation Mode does not generate comparison data.
- Check CI class: Dynamic IRE currently applies to cmdb_ci_hardware and its child classes. Ensure your test CIs belong to an eligible class.
- Verify comparison property: Check glide.identification_engine.dynamic_ire.auto_compare. It should be set to true.
- Check comparison records: Open cmdb_ire_output_comparison_item.list and verify whether records are being generated.
- Allow sufficient time: Run simulation through a Discovery cycle and then review the parity score and comparison charts.
Also, a 100% parity score alone doesn't confirm that meaningful comparisons have been performed, especially when no comparison records are available.
*************************************************************************************************************************************
If this response helps, please mark it as Accept as Solution and Helpful.
Doing so helps others in the community and encourages me to keep contributing.
Regards
Vaishali Singh
Linkedin - https://www.linkedin.com/in/vaishali-singh-2273361bb