Dynamic IRE

sntech
Tera Contributor

Hello,

 

I have implemented Dynamic IRE in simulation mode. In simulation mode, I am not able to see any comparison.

 

Can anyone please guide on this?

sntech_0-1794831660199.png

 

 

Thanks.

1 REPLY 1

vaishali231
Mega Sage

Hey @sntech 

In Dynamic IRE Simulation Mode, both Dynamic IRE and Static IRE process the same incoming CI payload in parallel. The comparison results are stored in the cmdb_ire_output_comparison_item table.

I would suggest checking the following:

  1. Trigger CI ingestion: Run a Discovery cycle or send CI payloads through the IRE API. Simply enabling Simulation Mode does not generate comparison data.
  2. Check CI class: Dynamic IRE currently applies to cmdb_ci_hardware and its child classes. Ensure your test CIs belong to an eligible class.
  3. Verify comparison property: Check glide.identification_engine.dynamic_ire.auto_compare. It should be set to true.
  4. Check comparison records: Open cmdb_ire_output_comparison_item.list and verify whether records are being generated.
  5. Allow sufficient time: Run simulation through a Discovery cycle and then review the parity score and comparison charts.

Also, a 100% parity score alone doesn't confirm that meaningful comparisons have been performed, especially when no comparison records are available.

*************************************************************************************************************************************

If this response helps, please mark it as Accept as Solution and Helpful.

Doing so helps others in the community and encourages me to keep contributing.

Regards

Vaishali Singh
Linkedin - https://www.linkedin.com/in/vaishali-singh-2273361bb