Service Graph Connector for Microsoft Intune - Delta sync
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-15-2024 07:03 AM
Hi
Pls anyone advise, how can we configure connector to pull the data which has modified since the last run rather the full upload.
Kindly advise
Regards
Bhupesh
- Labels:
-
Service Graph
-
Service Graph Connector
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-18-2024 03:41 AM
Hi @BhupeshG ,
The best way to modified any connector use the ETL -HUB to do the modification of any graph connector.
Also 1st time only connector run the full data upload in CMDB target table but next time when you run the connector again , it will only collect the delta data and upload in CMDB only.
Please appreciate the efforts of community contributors by marking appropriate response as Mark my Answer Helpful or Accept Solution this may help other community users to follow correct solution in future.
Thanks
AJ
Linkedin Profile:- https://www.linkedin.com/in/ajay-kumar-66a91385/
ServiceNow Community Rising Star 2024
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-18-2024 03:44 AM
but ajay that is not the case. Otherwise i have not reached here.
There is no setting where it does the delta load
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-18-2024 04:07 AM
Hi @BhupeshG ,
yes there is no setting , in Import set or staging table, complete data will fetch but only target table upload with delta data only.
Please appreciate the efforts of community contributors by marking appropriate response as Mark my Answer Helpful or Accept Solution this may help other community users to follow correct solution in future.
Thanks
AJ
Linkedin Profile:- https://www.linkedin.com/in/ajay-kumar-66a91385/
ServiceNow Community Rising Star 2024
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-05-2024 08:15 AM
I had the same question. I understand that if a record doesn't have updates it won't be updated. I feel it would be preferrable that the full data set not be pulled every time. The pulling of the full data set is very slow. If it only pulled the records that were updated in the past day, it would make the integration much faster and more efficient.