Guys, I'm trying to do some flows and when I go to do the tests, the reports don't look like it, I can't see anything from the report in any of the tabs,
Do you know when you do a flow and test it, it shows where you entered and if you completed the flow or if there was an error? Then it's GONE, it's gone and I can't see the tests, and even when I activate the flow blindly it doesn't run straight and I don't know why.
Does anyone know how to see the report as it was before?
Hi @Arthur Sanchez ,
Check the property "com.snc.process_flow.reporting.level" is enabled or not or
Navigate to Flow -> property - enable the below property
Please mark this comment as Correct Answer/Helpful if it helped you.
Regards,
Swathi Sarang
So bro, I don't know why the error appears, it doesn't show anything and I have these settings and NOTHING HAPPENS
