ATF error message

rtrr · ‎09-12-2018

Hi,

I created a script as image attached and the error message is the value is not right but that is set right shoul appears Admin Test

Mark Stanger · ‎09-13-2018

That's all captured in update sets. You can go back into the update set you've been working and see all of the update records for the test and the test steps. You can either move those to a different update set (by changing the 'Update set' reference field) or create a new update set and make a quick change to any existing record that you want to include in your new update set. Good luck!

View solution in original post

Mark Stanger · ‎09-13-2018

Is the 'Assigned to' field available on the incident form? It's not enough to have it on the table, it needs to be part of the incident form view for the test to work.

The error message is telling you that you need to configure the incident form and add the 'Assigned to' field there.

Mark Stanger · ‎09-13-2018

If you can post the screenshot of your incident form that might help.

rtrr · ‎09-13-2018

Yes when I select the table that appears and on screenshot the ATF got after run as image "fail3"

Mark Stanger · ‎09-13-2018

Okay, what happens if you de-activate all of the test steps but just impersonate, open the form, and then set the 'Assigned to' field. Does it set successfully?

rtrr · ‎09-13-2018

Yes. That runs normally with only that 3 steps impersonate/open form/set value to assigned to