CSM workspace UI builder

harish1995
Mega Explorer

Hi Everyone,

I have created a custom CSM Workspace using UI Builder and configured the following components:

Created a custom CSM Workspace.

Created a Record Page using the out-of-the-box (OOB) CSM Default Record page.

Created and configured a List Page to display case records.

Mapped the appropriate table and Sys ID between the list and record page.

The case records are displaying correctly in the workspace list. However, when I click on any case record from the list, I receive the following error:

"The page you are looking for could not be found."

I have already verified that the table mapping and Sys ID configuration are correct, but the issue still persists.


Has anyone encountered a similar issue while creating a custom CSM Workspace using UI Builder?

Any guidance or step-by-step suggestions to resolve this issue would be greatly appreciated.


Thanks in advance!

1 REPLY 1

Tarun Rekandar
Giga Guru

Hi @harish1995,

 

Please check the following in UI Builder:

  1. Record Page Route: Ensure the record page is published and has the correct route configured for the Case table.

  2. List Navigation: Verify that the list's row-click action navigates to the correct record page and passes the Case record's sys_id.

  3. Page Parameters: Check that the record page uses the correct table and record parameters expected by the OOB CSM Default Record page.

  4. Page Variants: Verify that the correct page variant is active for your custom CSM Workspace.

  5. Workspace Configuration: Confirm that the record page is available and properly mapped to your custom workspace.

As a troubleshooting step, try opening an existing Case record directly in the OOB CSM Workspace. If it works there, compare its navigation configuration with your custom workspace.

 

Accept the solution if it assisted you with your question & Mark this response as Helpful.

 

Regards,

Tarun