Data Management Update Job Rollback error

[YichenHuang]

When I was conducting a test, I used the update job to modify the CI status as follows:

1. Changed non-operational statuses to operational.
2. Changed operational statuses to non-operational.

At this point, I wanted to roll back the changes. I first attempted to roll back job 1, but an error message appeared on the screen (as shown in the attached image). Then, I tried rolling back job 2, which was successful. After that, I attempted to roll back job 1 again, and this time it was also successful.

I suspect that rolling back job 1 first resulted in all CIs in the instance becoming non-operational, which may have caused the error.

I’d like to confirm if this assumption is correct.
Thank you very much!

[YichenHuang]

We can only revert the sequence that is marked as current version, that why we can only perform rollback the newest record to the oldest

変更を元に戻す