Data Management Update Job Rollback error
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
ā03-10-2025 09:55 PM
When I was conducting a test, I used the update job to modify the CI status as follows:
- Changed non-operational statuses to operational.
- Changed operational statuses to non-operational.
At this point, I wanted to roll back the changes. I first attempted to roll back job 1, but an error message appeared on the screen (as shown in the attached image). Then, I tried rolling back job 2, which was successful. After that, I attempted to roll back job 1 again, and this time it was also successful.
I suspect that rolling back job 1 first resulted in all CIs in the instance becoming non-operational, which may have caused the error.
Iād like to confirm if this assumption is correct.
Thank you very much!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
ā03-13-2025 09:17 PM
We can only revert the sequence that is marked as current version, that why we can only perform rollback the newest record to the oldest
