Flow Designer - Issue selecting Approval group

[Aram Sosa]

Hi there! I am re-creating an old Flow. The idea is to create it exactly the same (or as similar as possible).

In step 1 in my original flow, approval is required, and the selected group is “Enterprise Architect Group - Record Created” (As in the image below shows):

My problem is that, recreating the flow, when I want to select this group, I only get “Enterprise Architect Group”, without the “Record created”. As seen in the following image:

Does anyone know what happens or how can I select it just like in the original Flow?
Both Flows are in the same instance, so the information is exactly the same.

All help is welcome and much appreciated!

[Yaramala]

Hello @Aram Sosa 

In your original workflow, it looks like they were using a Before Executed Step, whereas in your case, you are assigning the group directly.

Could you provide more images of your original workflow? This will help in identifying any missing steps or conditions that might be influencing the process.

If this addresses your question, please mark this response as Accepted Solution and/or give it a Kudos if you find it helpful.

Thank you!

[Aram Sosa]

In the original flow, there is only one step before it, and that is a condition, as seen in the screenshot:

[Rohit Singh]

Hi @Aram Sosa 

Try to copy the original flow rather then re-creating it and then check if you are getting the same group in the Approval.

If my response helped please mark it correct and close the thread so that it benefits future readers.

Regards,

Rohit 

[Aram Sosa]

I do not copy it, because apparently there is some strange error that does not allow me to copy it. When I click on “copy flow” , I get the following error as a notification:

And apparently, I can't save and activate my manually re-created copy either, because of the same error....