Heatmap report - changing colors

[roneisenberg]

Hello,

Please assist me in how I would change the colors displayed on the heatmap report?

The default color scheme is from a light blue to dark blue.

I would like to provide conditions to reflect green, yellow and red depending on the column the number appears.

Thank you

[srilu]

Hi Ron,

In the report ,change the chart color in the general settings to this

Go to chart colors under reports

Defined the column and the table colors there, so when you use those columns it will pick up those automatically.

Please let me know if this works.

Thanks

Sri

[roneisenberg]

Thank you for your response.

I have tried following your directions and it appears a little different in Geneva.

The general settings of the report allow you to have two colors (from min. to high).

I tried to do low green and high red, but there was no way to show a medium of yellow.

Do you know of a way to also have a medium?

[seperately, I created a chart color with three color components. (Green,yellow,red) - however, I couldn't figure out how to apply that chart color scheme to the actual report due to geneva not showing a 'color scheme' when it comes to a chart type of 'heat map'.

Do you have any other ideas on creating a green, yellow red heat map in Geneva?

Thank you

[srilu · Accepted solution]

Hi Ron,

For HeatMap we have only min and max to try, but for the bar chart type we have different options.

But for HeatMap based on the colors what you are using you can use these in max and min

the color will have slight yellow also in between

The other way green to red

Hope this helps..

[roneisenberg]

Thank you.   This was very helpful