How to Remove modules from the separator?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎05-04-2022 12:30 AM
Hi Team,
I trying to remove the modules from the separator and to add those modules just below the separator. I have tried to by changing the order of the separator and the modules I wanted to remove from the separator. But the those modules are not getting separated, if I collapse the separator all the modules under the separator are getting collapsed.
I need Request for Quotations and Vendor Quotes to come out of the separator, these should be arranged at the bottom of the separator. Is it possible to do?
Any suggestions are helpful.
Thanks in Advance,
Yesh

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎05-04-2022 12:45 AM
I think you would need to move the modules above the separator, or just add another separator for the remaining modules. The way it behaves is that anything with an order higher than the current separator will be contained in it, until it hits the next separator etc.

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎05-04-2022 01:09 AM
Hi Yash,
I guess the best approach would be to move these modules above all the separator by lowering the order. Any module which has a higher order than separator will be captured in the separator.
Regards,
Deepankar Mathur

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎05-04-2022 01:30 AM
Hi,
You will need to give the order value more than other modules for the particular separator for Request for Quotations and Vendor Quotes.
For example:
Here Decom Discovery Link type is Seperator,
So for Decom Executive Process Module give the order next to the Questionnaire.
For ex:
If Questionnaire is 700
Give the order as 800 for Decom Discovery
Mark my answer correct & Helpful, if Applicable.
Thanks,
Sandeep
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎06-19-2023 09:03 AM
@Community Alums
I have a little different problem here. hope you can help me.
I have created a Module under IT GRC (apart from below 3 in Screenshot) Which should be under the Seperator Nessus like 3.But I am unable to add it under it .
Orders of modules are as follows.
Nessus (250)
285 (New Module Order)// This does not add !
285 (existing Module order)
292 (existing Module order)
293(existing Module order)
Any Leads ?
TIA