I need to customize the fields that shows below the list collector on RITM and SC Task.

[Charutha R]

I need to customize the fields that shows below the list collector on RITM and SC Task. I have tried to configure it from the reference table (list collector reference table), Configure --List layout but it still shows the same fields.

[Ankur Bawiskar · Accepted solution]

@Charutha R 

you can configure view "sys_ref_list" on the table being referred by list collector and then add/remove fields

How to configure the fields shown after clicking an item in a list collector (slushbucket) 

Customizing the information displayed below the list collector catalog variable (slushbucket) after ... 

💡 If my response helped, please mark it as correct ✅ and close the thread 🔒— this helps future readers find the solution faster! 🙏

[Ankur Bawiskar · Accepted solution]

@Charutha R 

you can configure view "sys_ref_list" on the table being referred by list collector and then add/remove fields

How to configure the fields shown after clicking an item in a list collector (slushbucket) 

Customizing the information displayed below the list collector catalog variable (slushbucket) after ... 

💡 If my response helped, please mark it as correct ✅ and close the thread 🔒— this helps future readers find the solution faster! 🙏

[Ankur Bawiskar · Accepted solution]

@Charutha R 

Hope you are doing good.

Did my reply answer your question?

💡 If my response helped, please mark it as correct ✅ and close the thread 🔒— this helps future readers find the solution faster! 🙏