If approval state changes to "no longer Requried" The flow disgner was stack

[Siva82]

Hi Team,

I have a new requirement. When the approval state is changed to (manually) "No Longer Required," the flow designer should proceed to a new flow action. However, the flow designer is currently getting stuck at the "Ask Approval" action.

Could you please assist me with this issue?

Thank you in advance!

Best regards,
Siva

[Siva82]

Hi @Ankur Bawiskar 

I have a new requirement. When the approval state is changed to (manually) "No Longer Required," the flow designer should proceed to a new flow action. However, the flow designer is currently getting stuck at the "Ask Approval" action.

Could you please assist me with this issue?

Thank you in advance!

Best regards,
Siva

[TejaswiniY]

Hello @Siva82 

Could you please share a screenshot of the flow execution and you configured approval step.

In Flow Designer, to proceed with the flow after any approval is granted, the flow step should be configured as follows:

• Under Rules, select "Approve or Reject".
• Set the option to allow "Anyone can approve or reject" to ensure that the flow moves forward when a single approver completes the actionIf this addresses your question, please mark this response as Accepted Solution and/or give it a Kudos if you find it helpful. 

Thanks 

TejaswiniY

[Najmuddin Mohd]

Hi @Siva82 ,

What I understand is, using Ask for Approval action, an approval is triggered and followed by that, you are manually changing it to No Longer Required.

Followed by Ask for Approval action, are you adding the conditions, if Approval state changes to No Longer Required, then do the following, if Approval state changes to Approved, then do the following .........

May be, if you did not add the "No Longer Required" condition in the flow, it is getting stop.


If the above information helps you, Kindly mark it as Helpful and Accept the solution.
Regards,
Najmuddin.