Not able to activate a flow

[_navin9898]

Hi All,

Good Morning!

I have deactivated OOB standard change flow but not able activate it back. Has anyone faced the same? If yes, can you please let me know how can I make it 'active' once again.

Best Regards,

Dubey

[Anand Kumar P]

Hi @_navin9898 ,

Check that it was still the older version of the flow not the latest one. Try activating the flow from the sys_hub_flow table.
Issue is cause of due to a corrupt data pill which had a missing reference which caused the Flow to not get activated. On adding the missing reference, the flow will be successfully activated.


Mark it as helpful and solution proposed if it serves your purpose.
Thanks,
Anand

[_navin9898]

Hi @Anand Kumar P 

Thank you for your response. I tried to make the flow 'active' by activating the flow from the sys_hub_flow table but was not able to do so due to security constraints. 

Could you please let me know, how can I add missing reference?

Best Regards,

Dubey

[Dr Atul G- LNG]

I tried but it did not work, either reset the PDI is only opttion.

[Ayushi12]

Hi @_navin9898
Refer:https://www.servicenow.com/community/developer-forum/servicenow-learning-74-revert-the-flow-designer...

Please mark this response as correct or helpful if it assisted you with your question.