- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-25-2018 03:03 PM
Variable editor not visible on catalog task form for some requests. Could it be ACL related issue? I checked the form layout and it seems fine
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-25-2018 03:56 PM
You need to specify for each variable where it will be shown when it comes to catalog task records. I don't think it's ACL-related but likely specifying in the workflow or variable config that the variable should be displayed on that task. This post explains what to check for.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-25-2018 03:56 PM
You need to specify for each variable where it will be shown when it comes to catalog task records. I don't think it's ACL-related but likely specifying in the workflow or variable config that the variable should be displayed on that task. This post explains what to check for.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-25-2018 04:54 PM
Hi Ravish,
On the Variable configuration there is a "Global" checkbox (you might need to add it to the form layout) , set it to true and you should be able to see the Variable in the Catalog task.
Hope this helps !!
