What is my approval request not getting approved?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-25-2025 11:55 AM
I have a catalog item that triggers an approval (below). The approval does get triggered but and if I do approve one of the requests, it just sits in the same waiting for approval status. It shows 1 approved and 2 are still Requested but the workflow execution is still showing it's waiting.
What's wrong?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-25-2025 12:16 PM - edited 07-25-2025 12:17 PM
Hi @e_wilber ,
While looking at the flow execution record, have you refreshed the record? The execution record may be showing that it is still in a waiting state if you had the record open when you went to approve the record, as it does not automatically refresh.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-25-2025 12:19 PM
Hi @e_wilber
Likely causes:
- User(s) not in the group. Make sure that the user who approved is truly part of the Security Operations group — check sys_user_grmember.
- Mismatch with "Approvers" logic. Even though "Anyone approves" is selected, if the group membership isn't set up right, the system may wait for more than one.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-25-2025 10:59 PM
Hi @e_wilber ,
have you seen on the record in scope if approval is triggered to the group members or not?