Duplicate assessment metrics and ATF error with "Set Component Value (Custom UI)" test step
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
yesterday
Hi All,
I am facing two issues when using the "Set Component Value (Custom UI)" test step in ATF:
When selecting assessment metric values, the component displays duplicate assessment metrics.
While running the ATF, it throws the error: "assessment metric value '0', component not found".
Could anyone please help me understand why these duplicate metrics appear and how to resolve the component not found error?
I have attached relevant screenshots and logs for reference.
Thanks in advance!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
18 hours ago
Hi @AshithaRedP
According to me you are not selecting the correct element.
Have you tried Manual Page Inspector?
Observe these values and you can get the action that you can perform on that element.
Regards
Shaqeel
***********************************************************************************************************************
If my response proves useful, please indicate its helpfulness by selecting "Accept as Solution" and " Helpful." This action benefits both the community and me.
***********************************************************************************************************************
Regards
Shaqeel
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
16 hours ago
Hi Shaqeel,
Thanks for reply.
Yes, I have tried with Manual Page Inspector and i am able set the values for assessment metrics
but when i run 2 nd time then the assessment metrics ID's values are changing dynamically. So that my ATF is throws the error: "assessment metric value '0', component not found".
Is there any solution to resolve this issue.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
16 hours ago
Hi Shaqeel,
Thanks for reply.
Yes, I have tried with Manual Page Inspector and i am able to set the assessments metric values
but when i was run my ATF test in 2 nd time it's throwing error because of assessments metric id values are changing dyonically.
Is there any solution to resolve this issue.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
15 hours ago
Hi Shaqeel,
Thanks for reply.
Yes, I have tried with Manual Page Inspector and i am able to set the assessments metric values
but when i was run My ATF test in 2 nd time it's throwing error because of assessments metric id values are changing dyonically.
Is there any solution to resolve this issue.