Unable to add control record to a adhoc-created risk
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
3 hours ago
Hi Team,
Unable to add control record to a adhoc-created risk. Eventhough both risk and controls are related to same entity. Please see the attached screenshots in sequence..
Help me understand if this is an expected behavior.. or is there any way to link control to an adhoc-ly created risk record..
Regards,
Mohd Arbaz.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
3 hours ago
Hello @mohdarbaz ,
Your setup seems correct..
It might fails to display error messages when a server side rule or permission silently aborts the insert into the table (sn_risk_m2m_risk_control).
Refer this :
control adding not wokring in risk record
If my response helped mark as helpful and accept the solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
3 hours ago
Hi @yashkamde ,
I have gone through the link that you have shared above.. and for me both 'Add' and 'New' are not working.
Regards,
Mohd Arbaz.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
an hour ago
Hi All,
FYI-Just to add further to this trail, I am able to successfully add control to ad-hoc risk in PDI. It's not allowing me in my client specific environment.
Regards,
Mohd Arbaz.