How can entry points be added to a service application using Flow Designer or bulk upload?

[CScruggs]

I have ~50 IP Addresses to add as TCP entry points to an application service.  Is there a way to add these either by bulk upload or flow designer instead? 

[Community Alums]

Hi @CScruggs ,

You can create a template with entry points & other basic metadata that describes a Service.  Then upload that spreadsheet into the SM home page, to provide a list of Candidate Entry points (same items that could be found when discovering a load balancer, etc).

WARNING: A best practice is to limit services to ~50 nodes or so.  If you have 300 CI's related to a single service, that could be a early warning sign that perhaps your service is defined too broadly... and hence look for ways to break it down to smaller, more managable services.  That may not be practical... i don't know your specifics ... just FYI that 300 is a lot for a single map.

Also, refer to this doc:https://docs.servicenow.com/bundle/rome-it-operations-management/page/product/service-mapping/task/i...

Mark my answer correct & Helpful, if Applicable.

Thanks,

Sandeep

[Community Alums]

Hi @CScruggs ,

Any update to this ?Any follow-up required? if not

Kindly mark the answer as Correct & Helpful both such that others can get help.

Thanks,
Sandeep

[Community Alums]

Hi @CScruggs ,

Any update to this ?Any follow-up required? if not

Kindly mark the answer as Correct & Helpful both such that others can get help.

Thanks,
Sandeep

[CScruggs]

Is there a document that refers to how to do this.  The link to the doc you provided are instructions for uploading multiple application services, not application service multiple entry points.