Is it possible to discover Server BMC(Baseboard Management Controller)?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎04-10-2024 06:18 PM
Can't find BMC discovery for monitoring server Hardware.
Is it possible to discover Server BMC(Baseboard Management Controller)?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎04-10-2024 11:48 PM
Hi @Hank Woo ,
Good Day
Correct me if I am wrong, baseboard management controller (BMC) is a specialized service processor that remotely monitors the physical state of a host system, such as a computer, network server or other hardware devices.
A baseboard management controller (BMC) is a small, specialized processor used for remote monitoring and management of a host system. Usually an ARM-based SoC (System on Chip) with graphics and control logic built in, it is commonly located on the main motherboard of the computer, server, network or storage device (the "baseboard"), can be accessed remotely either via a dedicated or shared network connection, and has multiple connections to the host system, giving it an ability to monitor hardware via sensors, flash BIOS/ UEFI firmware, give console access via serial or physical / virtual KVM, power cycle the host, and log events.
Its is not a Device with IP enable, its a component or chip which available of matherboad, This is something available on Server which monitor the Host.
As far as i know, ServiceNow discovery not providing any capability to discovery the BMC as of now.
Please appreciate the efforts of community contributors by marking appropriate response as Mark my Answer Helpful or Accept Solution this may help other community users to follow correct solution in future.
Thanks
AJ
Linkedin Profile:- https://www.linkedin.com/in/ajay-kumar-66a91385/
ServiceNow Community Rising Star 2024
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎04-11-2024 05:05 PM
Hello @AJ-TechTrek ,
Thanks for kindly answer.
BMC is a small processor, but it has it's own ip address.
So If BMC is enabled, I can connect to server regardless of host OS.
For example, If OS is changed(so OS IP is also changed) and OS is not installed, I can connect and monitor to server by BMC IP address.
My infrastructure have a lot of changes espicially IP addresses but not BMC ip address.
Best regards,
Hank.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎07-03-2024 04:33 AM
Did you find any solution of this I am facing the same issue?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎07-03-2024 05:34 PM
What server are you using?
There is only DELL iDRAC probe.
If you use a server other than this, you need to create your own discovery pattern.
In my case, I didn't make discovery pattern, but only SEL of each server was collected and delivered to mid server.