Set closed_by to system
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-27-2024 12:26 PM
I am trying to set closed_by to system in a scheduled job that would automatically close the record that match certain conditions. How can I do that? There is no System Admin in the User table but job runs as system. Tried to set displayvalue to system and it did not work. Any way to set this?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-29-2024 07:56 PM
Hope you are doing good.
Did my reply answer your question?
If my response helped please mark it correct and close the thread so that it benefits future readers.
Ankur
✨ Certified Technical Architect || ✨ 9x ServiceNow MVP || ✨ ServiceNow Community Leader
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-30-2024 05:20 AM
No luck, I tried to set the value but it is still empty. Tried to use set Value as well. no luck