
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-23-2019 04:07 PM
Hi I am looking for help and i am setting up a walk-up experience and the check-in is closed at 23:30 and not 23:59. DOes the check-in have a 30 mins early closing time?
Checkin Screen below.
We are closed. Please refer to the hours of operation.
Next available time
Monday, Jun 24th
8:00am - 11:59pm
Thanks
Solved! Go to Solution.
- Labels:
-
Walk-Up Experience
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-25-2019 05:44 PM
Always. Any change that you plan to make in your instance, it's always recommended to do that in your DEV instance first, test it out and once successful, apply the change to Production.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-23-2019 10:05 PM
Hi Jerry
With a very quick installation of this application, I got the following that you could check:
There is a field on the 'Walk-up location queues' module, called 'Last check-in', the value of which is 30 minutes by default. In order to allow check-ins till the last minute, you can remove this value and leave the field blank.
To locate this field, please follow the below steps:
1) Navigate to Walk-up Experience > Administration > Walk-up Locations
2) Open the location record for which you would like to update the last check-in value
3) Remove any value from this field
This field is basically used to disable check-ins 'X' minutes prior to the scheduled close time.
Please mark this answer CORRECT/HELPFUL if it solved your query.

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-25-2019 03:47 PM
Much appreciated on this 🙂 i will test this out. Is it best practive to make the changes in dev as a local update set?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-25-2019 05:44 PM
Always. Any change that you plan to make in your instance, it's always recommended to do that in your DEV instance first, test it out and once successful, apply the change to Production.