Unable to wake my instance
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-14-2025 02:53 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-14-2025 03:11 AM
Hi @DevS78964745564 ,
What can I do if my PDI doesn't wake up from hibernation?
If your PDI does not wake up, give it time. PDIs usually take three to five minutes to wake up and should not take any longer than 20 minutes. If your PDI does not wake up, try again later. If your PDI still does not wake up after trying again later, release the PDI and request a new PDI.
Can I get my old PDI back?
No, you cannot. You can apply your saved work to a new PDI to get it to match your old PDI. The best way to save your work is to save it to source control or update sets. You can then apply your saved work to another PDI.
refer this for more info
Please mark my answer as helpful/correct if it resolves your query.
Regards,
Chaitanya
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-14-2025 05:38 AM
When I logged in this morning I got a banner that there was a known issue with waking hibernating instances. This may be the cause of your problem. They say they're working on it. Good Luck! Joe
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-14-2025 05:37 AM
When I logged in this morning I got a banner that there was a known issue with waking hibernating instances. This may be the cause of your problem. They say they're working on it. Good Luck! Joe
