I’ve integrated the ribbon into our csm configurable workspace, specifically using the ‘Preset - Record’ ribbon. However, when I’m in UI Builder, it indicates that the component isn’t configured, even though it actually is. Additionally, when I load the record form, the ribbon component appears and still displays the ‘not configured’ message. Strangely, once the rest of the record finishes loading, everything looks fine. Why does this component show as unconfigured in UI Builder and when the form is loading in the workspace, and why does it appear before the rest of the form?
Ribbon once the form fully loads:
ribbon component shows as "not configured" in UI Builder when its configured with the preset:
Ribbon appears as "not configured" while the rest of the form is still loading (I also have an iframe component that shows up before the rest of the form is fully loaded as well):
Following additional testing and research, I believe that the ribbon and iframe components appear while the form is still loading because they are not connected to the loader. I assume that other components are properly connected. These two components—the ribbon and iframe—were added on top of the out-of-the-box (OOB) record page for the CSM Configurable workspace. However, I’m uncertain about where to configure these components to synchronize with the loading state like the rest of the components. Any guidance or advice would be appreciated!
