ATF Set Variable Values (SP) returns an error for certain variables
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-30-2023 06:33 AM
When creating a new ATF test step, Set Variable Values (SP) for some variables I get this error:
This does not happen with all variables. I cannot figure out what is different. Has anybody seen this error before?
Thanks,
Joe
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-30-2023 07:11 AM
Can you try submitting catalog item manually with whatever variable values you are putting in the ATF Step?
Sometimes if the data you are setting in ATF Step variables is not appropriate, you may get random errors.
Also make sure whatever variables your are trying to set, are visible on the catalog item, those shouldn't be getting hidden by some onLoad / onChange client script.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-30-2023 07:17 AM
The catalog item works fine. Most of the variables are okay to set in the test step, just two mandatory variables are causing this error.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-14-2023 01:41 AM
Hi @jn1965
You can try unchecking the following and run again:
Regards
Shaqeel
***********************************************************************************************************************
If my response proves useful, please indicate its helpfulness by selecting "Accept as Solution" and " Helpful." This action benefits both the community and me.
***********************************************************************************************************************
Regards
Shaqeel
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-14-2024 07:36 PM
Client script is restricting the content you have added on the set variables , don't use any special characters, give a plain content and check, what is the type of the variable?