Devices failing UCS Discovery

[DarOB]

Hello,

I am trying to discover UCS using SNMP & the UCS-HD Pattern. I have been successful with a lot of devices. However I have been getting the below error when trying to discover 2 specific devices. These 2 devices have the exact same config as the successful devices and I have been able to login to the devices directly using the credential I am using for discovery. 

Identification Engine: Discovery status is FAILURE, Identification sections in pattern failed: section: discovery, error: Match step predicate is not matched. Failed Condition(s): [(${login} : value=login_failed) NOT CONTAINS "login_failed"] .

Why is discovery failing to login even though I can login directly to device using the credential?

Thanks in advance.  

[Divyank Gohil]

Hi @DarOB ,
Greetings!

Have you got any solution for the above mentioned error by you? 
As we are also facing same issue.

Thanks in Advance.

[DarOB]

Hi @Divyank Gohil - I have no found a solution yet, still experiencing same issue. I will update this case if a solution is found.

[goldenjc97]

Hi @DarOB  - Same issue here - did you get any update from the case?

[Sandeep Gunnam]

Hi @goldenjc97 

I don't have a specific reasoning for what I am mentioning here. But UCS has Side A and Side B, and at any moment of time only one side is active and will respond to logins. Check with your UCS admin team about this and they can provide you the exact reasoning on why it is happening like that.

In our environment, we were given 2 IP Addresses for discovering UCS devices and when we perform the discovery only 1 of the IP Address works. I will try to update this post if I find any material to support what I mentioned here.

Thanks,

Sandeep