Service Graph connector for Tanium

Suraj Chauhan
Tera Contributor

Hello,

I have installed the "Service Graph connector for Tanium" and the CI's are getting created fine. I have a question.

for all the assets created from this SGC , i want to always set the Support group to be always "ABC-support group"

I know, i can create a BR to achieve this, but can I configure this to be in the SGC itself ?

How can this be achieved?

thank you.

Suraj 

3 REPLIES 3

Not applicable

Yes, this can be done via a custom mapping to the support group field.

  • Install the IntegrationHub ETL application
  • Load up the SG Tanium Hardware and Software feed
  • In step 2 "Prepare Source Data for Mapping" create a new transform from fixed valuefind_real_file.png
  • In step 3 "Map Data to CMDB and Add Relationships" map the supportGroupSysId field to the support group column for the CI classes you want to track the support group of.
  • Run the integration and the CIs should have the support group populated and it will sync over to the asset.

Suraj Chauhan
Tera Contributor

i installed the INtegrationETL plugin and now i get the below error when trying to load the Tanium feed

Error Message

Read operation against 'sys_plugins' from scope 'sn_int_studio' has been refused due to the table's cross-scope access policy

First switch to the scope of Service Graph Connector for Tanium by clicking on the globe icon on the top right corner of banner, then try.