What is Step Config "Run Cleanse Serial Number Operation" in Test - ATF

[parsameera123]

Hi Folks,

I want to understand the below concept about ATF specially for CMDB ?
1. There is an existing Test "Test the Cleanse Serial Number Operation " what does it do and how do I test it?

2. There is a test step inside the above test mentioned where step config is "Run Cleanse Serial Number Operation". What does it do and how do I test it?

I would be glad if I get any input on this

Thanks in Advance!!!

[Ali543]

During the execution of a test case, the "Run Cleanse Serial Number Operation" step configuration triggers the automated execution of the cleanse operation on a specified serial number or a set of serial numbers. This step allows you to verify that the cleansing process functions correctly and produces the desired results.

The specific configuration details and parameters of the "Run Cleanse Serial Number Operation" step may vary based on your organization's customizations and requirements within ServiceNow's ATF. It is recommended to refer to your organization's documentation, test in RSO California case configurations, or reach out to your ServiceNow administrator for more specific information regarding this step configuration and its associated settings in your particular ATF setup.