Not seeing debug output
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎10-13-2017 01:01 AM
I had seen debug output with one client, so I tried to use 'gs.debug' myself, but I do not see any output?
I did notice the property 'glide.amb.log.level', which is set to 'info', but I'm not sure whether that's the culprit. Especially as I cannot decrease that value to 'debug' as it is maint only. Anyone any ideas?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎10-13-2017 01:04 AM
Hey Peter,
You could use this link
Please Hit ✅Correct, âÂ��Helpful, or ��Like depending on the impact of the response
Have a lovely day ahead
Regards,
Divya Mishra
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎10-13-2017 01:12 AM
That link is for scoped apps I'm using global and want the debug output in the Log table and not only in the output below, when you turn on debugging.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎10-13-2017 01:14 AM
If global, why don't you use gs.log() ?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎10-13-2017 01:17 AM
Because I'm not in Eureka anymore: Best Practices | Debugging in Fuji, part 1 of 2 - YouTube
