Remove filter when clicking the magnifying glass on a reference
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-22-2024 11:03 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-22-2024 11:07 AM - edited 04-22-2024 11:08 AM
Hi @Marc_007 ,
This shows that there is "default" filter applied.
You can open that reference field at table level and check the filter condition.
-Thanks,
AshishKM
Please mark this response as correct and helpful if it helps you can mark more that one reply as accepted solution
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-22-2024 11:18 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-22-2024 11:46 AM
can you share the module or form name and on which field this search icon applied .. need to check.
Please mark this response as correct and helpful if it helps you can mark more that one reply as accepted solution
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-23-2024 05:42 AM
Hello Ashish,
I added more attachments. When i add even real data in the search field(For ex: Record number for the record field of ref. table. The filter default is set to look at the state field. Even when i remove the filter the filter comes back on the next search. I am trying to figure out where that filter is inherited from. So far no luck.
