- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-15-2025 10:02 PM
Hello Team,
I am trying to create Custom Application using App Engine Studio, where on custom table I have created a custom reference field and trying to select the sys_user table but I am not able see the table from drop down please let me know if something is missing.
Regards,
Prudhvi
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-20-2025 01:00 AM
@Community Alums
Are you sure your sys_user table has Allow configuration checkbox checked?
If yes then only you can select your table during a field creation from other scope
If my response helped please mark it correct and close the thread so that it benefits future readers.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-15-2025 10:11 PM
Hello,
Please check for following thread:
Kindly mark my answer as correct or helpful.
Regards,
Kalyani Shaha
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-15-2025 10:32 PM
Hi @Kalyani21
I have gone through the above thread already, but the solution was not working for me. I made user table as Extensible but still same issue.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-15-2025 11:20 PM
Hi @Community Alums
Please create a cross-scope privilege to achieve this. For your reference please go through this.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-20-2025 01:00 AM
@Community Alums
Are you sure your sys_user table has Allow configuration checkbox checked?
If yes then only you can select your table during a field creation from other scope
If my response helped please mark it correct and close the thread so that it benefits future readers.