- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎11-29-2024 06:00 AM - edited ‎11-29-2024 06:01 AM
If I wanted to change the table where the data is being pulled from or the query that is being used for example on the "Epics in backlog that are ready" item on the Build tab, what I would need to do?
To be honest I haven't found any documentation or guidelines regarding this matter, only about configuration like hiding tabs or section.
 
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎03-13-2025 02:57 PM
Hi Yamilla,
This would require customizations through UIB. You'll need to clone the page and make a minor modification, but it means that that entire page is customized, and will not receive future updates. So, upgrading to newer releases will be difficult.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎03-13-2025 02:57 PM
Hi Yamilla,
This would require customizations through UIB. You'll need to clone the page and make a minor modification, but it means that that entire page is customized, and will not receive future updates. So, upgrading to newer releases will be difficult.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎04-22-2025 12:14 PM - edited ‎04-22-2025 12:18 PM
Some additional links that might be helpful:
DPM
Configuring: Configure the Digital Portfolio Management experience
Customizing: Launch and Learn: Digital Portfolio Management - Duplicating and Editing Pages
Needs Attention attributes