custom discovery pattern - Wireless access points - Cisco Waps

[Doci1]

Hi,

I tried to do custom pattern for Aruba Wireless Controller, basically I did the same, what is in extension of "Network switch" pattern, which is called "Cisco WAPs". So I did another extension and basically copied what is in "Cisco WAPs".

I am able to get what I need based on the OID, debug mode on, all info collected. But when I run discovery, it failed, with error "Reference and relation tables must be a CI Type, change wap_tb to a correct type."

As I simply copied, what is in OOTB "Cisco WAPs", my question is what is the Target Table - "$wap_tb", in that OOTB "Cisco WAPs" pattern? Where is it stored? I cannot find it anywhere. (I looked in network swith pattern and $wap_tb is not mentioned there)

[Doci1 · Accepted solution]

I will reply to myself. 

All the target tables are let say "made up" tables during pattern execution. You cannot find them anywhere. 

However I probably did a mistake, that whenever you define a new step, you have to always hit the "Test" button, so the Target table will "instantiated" into memory?? and therefore visible into the Temporary variables on the right side of custom pattern.