Dependency Mapping Not Displayed

[Nilanjan1]

Dear Experts, 

During the discovery of the Network Devices, I have seen that the dependency mapping is not being populated, but with CDP I can see the neighboring devices. 

Is it something that we see in the dependency mapping when there is an actual connection with devices OR there are some property that needs to be enabled. 

I did get some articles and went through the documentation but did not get a pointed answer for the same. 

Any help will be appreciated. 

Regards

Nilanjan

[Runjay Patel]

Hi @Nilanjan1 ,

check the relationship, and f it getting established then it will show in map.

[Nilanjan1]

Hi @Runjay Patel 

Thank you so  much for the reply. I have checked this and it is showing the relationships something like this but cannot be seen in the relationships, not sure why or do I need to have a neighboring device to see the relationship between CI whereas relationship is not displayed between the own interfaces and VLAN's-.

Regards,

Nilanjan

[Runjay Patel]

Hi @Nilanjan1 ,

if relationship are there for device then map should show the relationship. Try adding manual relationship and then see it is reflecting or not? Also it is happening for one ci or for all ci?

[Nilanjan1]

Hi @Runjay Patel , 

Thank you for your inputs, I have added this manually and have checked it with discovery again but no change.. it is happening for all the network CI except for stacked switches.