Discovery Errors
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-22-2024 07:24 AM
I can see the Active Discovery errors on the Discovery Dashboard but I would like to run a report to show them or export them.
I would then be able to filter them by IP Address, date, time, error message, etc
Does anyone know how to do this please.
We are on Washington release.
- Labels:
-
Discovery
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-22-2024 11:30 PM
Hi @Keith Revis ,
You can go to table or create a report based on the table "automation_error_instance_msg".
if my answer has helped with your question, please mark my answer as accepted solution and give a thumb up.
Best regards
Anders
If my answer has helped with your question, please mark my answer as the accepted solution and give a thumbs up.
Best regards
Anders
Rising star 2024
MVP 2025
linkedIn: https://www.linkedin.com/in/andersskovbjerg/
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-23-2024 01:53 AM
Hi,
I trust that the out-of-band (OOB) system displays error information. When you click on it, it should direct you to the 'discovery_active_error_list.do' table, where you can review the relevant details, such as the error message, date, time, and IP address. Please access that table, export the necessary information, and apply a filter to isolate only the Active Directory (AD) errors. PFB.
Suresh.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-23-2024 03:18 AM
Hi, this table is what you are looking for: [automation_error_msg].