Getting error when changing mid server during quick IP discovery

AbdulRahim
Tera Contributor

Hello team,

Need some help on the below issue

When a user tries to run quick IP discovery he is not able to select mid servers and gets below error message.

SS:

AbdulRahim_0-1744628916584.png


I did some analysis and found out there are read level acls on validated field and user doest have that role. but this working fine for him and suddenly he started facing issues what could have happened?

Thanks,
Rahim



3 REPLIES 3

Sayali_Suryawan
Tera Guru

You're partially right — it's possible that the user doesn't have the necessary access or role.

This could be due to a 'Read' ACL set on the table that includes a specific role. Please double-check the following:

  • Open the ACLs and review the Read ACLs configured on the table.

  • Check which roles are listed there.

  • Make sure the required users have been assigned the appropriate role.


    Or try MID Server User Issue


Please mark my response if it was helpful. 

Thanks @Sayali_Suryawan ,

Can you confirm what is the minimum role required to run quick ip discovery without giving user complete discovery_admin role?

Thanks,
Rahim

Sayali_Suryawan
Tera Guru

Hello AbdulRahim,

 

You can try giving users with discovery admin with snc_read_only roles.  The read-only role (snc_read_only) restricts a user or a group of users to read-only access on the tables to which the user already has access.

 

OR

 

You can create a custom role and apply it to the read ACL, but I'm not entirely sure if this will work without causing errors during the discovery process.

 

And in any case if it create issue then , it's best to use the discovery admin role.