please help me with learning - Service Mapping Advanced Simulator
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-23-2025 08:39 AM
I am stuck in
Task 12: Create Pattern Identification section for JBoss WildFly Part 2
Step 5 - Set configuration file name
- Use Parse Variable operation to parse the output from commandLine and find the location of the configuration file (defines where all deployments are listed)
- Define parsing as Command Line Unix Style
- Set the name of the configuration file to the variable config_file
- Hint: The configuration file is part of the command line.
Test
Note: Test should finish successfully with config_file value of standalone.xml
I tied But
Test results are coming as expected this step is stopping me to proceed further
Question:
what should i put in 1. Enter variable (all options i tried )
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-24-2025 10:18 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-26-2025 11:29 PM
Hi @Raju just check step 1 ,2 , 3 from below link and verify
if my answer helps you mark helpful and accept solution.