- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-22-2025 10:48 AM
I am following the steps in the Guided Setup for Walk-up Experience. When I get to the step to create a Appointment Booking Service Configuration record, I am faced with the 'Catalog item' field showing no results being returned even though there should be record producers present to be selected.
However, when I go into a sample record on this table, I am able to see records show up in that field that I can select.
Any guidance would be appreciated as I am unable to configure the records needed to test scheduling an appointment.
Note: I am logged in as System Administrator in two different instances and facing the same issue.
All instances have the Walk-up Experience plugin installed with demo data. The two screenshots are from my PDI.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-22-2025 12:32 PM
SOLUTION: I discovered that to successfully create a new record on the Appointment Booking Service Configuration table, it has to be done via a related list on the Appointment Booking Configuration table.
You have to go into the existing record named 'Walk-up Experience' on that table and then click new on the related list at the bottom of the form (see screenshot attached below).
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-22-2025 12:32 PM
SOLUTION: I discovered that to successfully create a new record on the Appointment Booking Service Configuration table, it has to be done via a related list on the Appointment Booking Configuration table.
You have to go into the existing record named 'Walk-up Experience' on that table and then click new on the related list at the bottom of the form (see screenshot attached below).
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-22-2025 03:08 PM
Changing the application scope from global to Walk-up experience solved this for me.