in ATF while i am creating ATF in the Set Variable values (SP) i can't see the solution type
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-14-2024 10:55 PM
Hi,
in ATF while i am creating ATF in the Set Variable values (SP) i can't see the solution type, where as i can see it in the manually.
Please find the below ATF test.
Please help me out with the reason.
Thanks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-15-2024 01:06 AM - edited 05-15-2024 01:07 AM
The client test runner should be open throughout the retrieval process.
Regards
Shaqeel
***********************************************************************************************************************
If my response proves useful, please indicate its helpfulness by selecting "Accept as Solution" and " Helpful." This action benefits both the community and me.
***********************************************************************************************************************
Regards
Shaqeel
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-15-2024 02:11 AM
Sure, let me try this from my side.
I will keep you update the results.
Thanks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-15-2024 02:17 AM
Hi,
Once completed the Set component value step it is showing the above window which should i select here.
Please help me on the same.
Thanks,