- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-10-2024 11:43 AM
Hi,
While performing the Transform map i am not able to find the table which is created by me
I have created a table called ccid which is mentioned in the below screenshot:
If i am doing the transform map i can't see that table in the list :
But in target table i can see my table which is mentioned below:
Any reason why i am not able to see my table into the "Source table" please help me out on the same
Thanks
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-10-2024 11:56 AM
@kranthi2 : The source table shows only the list of all staging tables. It shows only the tables that extend "Import Set Row." Below is the article that helps you understand better on staging table.
Please mark this as correct answer and helpful if it resolved, or mark this helpful if this help you to reach towards solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-10-2024 11:56 AM
@kranthi2 : The source table shows only the list of all staging tables. It shows only the tables that extend "Import Set Row." Below is the article that helps you understand better on staging table.
Please mark this as correct answer and helpful if it resolved, or mark this helpful if this help you to reach towards solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-10-2024 09:41 PM
Hi @kranthi2
1. Go to System Import Sets > Load Data.
2. Create a New Staging table(import set table) from which you import the data.
3. Select your file (if is in csv or xlsx).
4. Now select your source table and target table as per convenience.
Please Mark this as Helpful/Accepted if this solves your query.
Thanks& Regards
Deepak Sharma