ATF fails with no error message
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎11-28-2024 01:29 AM
Just want to check if there are anyone else experiencing issues with the ATF test steps when using a different Form UI option besides from the Standard UI.
I'm trying to create a test that would check if a specific form can be created and modify using CSM/FSM Configurable Workspace but even before running it sends out a failure state and when checked the result logs it just shows pending as the status with blank summary.
If you can provide a resolution or any insight on what can cause this that would be awesome.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎11-28-2024 06:14 AM
support for Next experience is limited in ATF.
You can try to use Custom UI step.
If my response helped please mark it correct and close the thread so that it benefits future readers.
Ankur
✨ Certified Technical Architect || ✨ 9x ServiceNow MVP || ✨ ServiceNow Community Leader